BALANCED TRS.RT CABLE

BALANCED TRS.RT CABLE

$ 87.00$ 114.00

Type your text in the box below

SKU: INTEXCABLETRSRT Category:

Description

Instrument TRS cables (stands for Tip – Ring – Sleeve) are also known as “Balanced” or “Stereo” although the latter is misleading. These cables are designed to interconnect pro audio gear with balanced phone jacks. You will also find TRS connectors on the stem of Y cables. These are used for mixer insert jacks where the signal is sent out through one wire and comes back in through the other. TRS cables are typically used for mono, not stereo, signals in most studio gear hence the confusion. The most typical application of a “Stereo” cable would be for running both left and right mono signals to stereo headphones.

A balanced electrical signal runs along three wires: a ground, a positive leg, and a negative leg. Both legs carry the same signal but in opposite polarity to each other. Any noise picked up along the cable run will typically be common to both legs. Assuming the destination is balanced, the receiving device will “flip” one signal and put the two signals back into polarity with each other. This causes the common noise to be out of phase with itself, thus being eliminated. This noise cancellation is called “Common Mode Rejection” and is the reason balanced lines are generally best for long cable runs.

Personalized engraving is available on the TRS.ST connector. Personalizing individual cables reduces the occurrence of another band mate packing away the wrong cable or worse. The longest name we’ve done is Yngwie Malmsteen, so 16 characters is the limit per line.

This is the right angle version of the BALANCED TRS.ST CABLE, the right angle connector used is a Switchcraft 236.

INTEX cables are completely hand made from the finest components available. All connector parts are made of solid metal, from the brass M642/2-2 Military Spec connector & custom engineered shell to the plated steel stress relief spring. All cables are handmade with Belden 8412, an industry standard microphone cable for over 40 years. No compression or crimping is used to attach cable to connector, INTEX cables are welded insuring the strongest and most durable connection possible.

If you need a length that’s not listed, contact us at [email protected].

Additional information

Specifications

Capacitance between conductors = 98 pf/M (30 pf/ft)
Jacket = 0.89mm (0.035 in)
Conductor AWG = 20 (26 X 34)
Conductor material = ETP high-conductivity copper (99.95% pure copper).
Insulation & outer jacket material = EPDM Rubber (Ethylene Propylene Diene Rubber)
Operating temperature range = -50 deg. C to +90 deg.C (-58 deg. F to 194 deg. F)
Maximum recommended pulling tension = 45.45 Kg (100 lbs)
Minimum bend radius (install) / minor axis = 70 mm (2.750 in)
EU ROHS Compliance = 01/01/2004
Nominal inductance = 0.055 uH/M (0.18 uH/ft)
Nominal conductor DC resistance @ 20 deg. C = 32 ohm/1000M (10.6 ohm/1000ft)
Nominal outer shield DC resistance @ 20 deg. C = 13.7 ohm/1000M (4.5 ohm/1000ft)

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.